Show simple item record

dc.contributor.authorD. S. Murthy
dc.contributor.authorS. V. Sivakumar
dc.contributor.authorKeshav Kant
dc.contributor.authorD. P. Rao
dc.date.accessioned2017-05-09T00:28:56Z
dc.date.available2017-05-09T00:28:56Z
dc.date.copyrightSeptember, 2008
dc.date.issued2008
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27843#091801_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/138469
dc.description.abstractThe solid-gas contacting for thermal storage and thermal recovery is generally carried out in fixed-bed regenerators. Compared to a fixed bed, higher thermal recovery can be achieved in a moving bed with countercurrent flow of gas and solids. However, the moving beds have not been widely used due to difficulties in solid handling. The relative movement of the bed to the gas flow can be simulated in a fixed bed by moving the inlet and outlet ports of the gas along the length of the bed. Similar simulated moving beds are already in use for adsorptive separation of liquid mixtures in chemical industries. A novel moving-port system is proposed to achieve simulated moving-bed operation in a fixed bed. We have carried out studies to evaluate the relative performance of the fixed and the simulated moving-bed heat regenerators. We have examined the feasibility of replacing a set of three blast furnaces and thermal regeneration of an adsorption bed with the simulated moving-bed regenerator. It is found that high-heat transfer intensification can be achieved. The results indicate that three blast-furnace stoves can be replaced by a simulated moving-bed regenerator of volume of about 100 times smaller than the stoves. The heat-transfer intensification is high enough to carry out thermal regeneration of the adsorption beds in a cycle time that is in the range of the pressure swing adsorption, which is favored for its faster rate of regeneration.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleProcess Intensification in a “Simulated Moving-Bed” Heat Regenerator
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue9
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2927397
dc.journal.fristpage91801
dc.identifier.eissn1528-8943
dc.keywordsHeat
dc.keywordsHeat transfer
dc.keywordsTemperature
dc.keywordsParticulate matter
dc.keywordsSolids
dc.keywordsFlow (Dynamics)
dc.keywordsHeating AND Blast furnaces
dc.treeJournal of Heat Transfer:;2008:;volume( 130 ):;issue: 009
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record