Show simple item record

dc.contributor.authorPietro Garibaldi
dc.contributor.authorMario Misale
dc.date.accessioned2017-05-09T00:28:55Z
dc.date.available2017-05-09T00:28:55Z
dc.date.copyrightOctober, 2008
dc.date.issued2008
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27845#104506_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/138461
dc.description.abstractThe aim of this work is to analyze experimentally the influence of geometrical parameters and fluid properties on the thermal performances of rectangular single-phase natural circulation miniloops, which could be used for cooling of electronic devices. The present paper analyzes two experimental campaigns performed on two rectangular miniloops (ML1 and ML2), characterized by different heights, when two working fluids (water and FC43) are employed. The temperature trends are measured for different combinations of miniloop inclination and power, and the associated fluid velocities are calculated by means of an enthalpy balance. The experimental data are compared with Vijayan’s model, developed for large scale loops in steady-state conditions, corrected with a parameter that takes into account the loop inclination. The dynamical behavior is always stable. The time of the initial transient is long at high miniloop inclination (close to horizontal) and at low power, while the temperature overshoot grows up with increasing power and inclination. Results show that at the same power the velocity of FC43 is almost twice than that of water, but the thermal performances are worse because FC43 is characterized by low specific heat. Moreover, the velocities of the tallest miniloop are the lowest, probably because the enhancement of shear stresses overcomes the increase in buoyancy forces. For both fluids, the velocity grows almost linearly with power. Experimental data show a good agreement with the modified Vijayan’s model.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperiments in Single-Phase Natural Circulation Miniloops With Different Working Fluids and Geometries
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue10
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2948393
dc.journal.fristpage104506
dc.identifier.eissn1528-8943
dc.keywordsTemperature
dc.keywordsFluids
dc.keywordsSteady state
dc.keywordsWater
dc.keywordsForce
dc.keywordsBuoyancy
dc.keywordsStress
dc.keywordsShear (Mechanics) AND Specific heat
dc.treeJournal of Heat Transfer:;2008:;volume( 130 ):;issue: 010
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record