Show simple item record

dc.contributor.authorSalil Mohan
dc.contributor.authorMikhaylo A. Trunov
dc.contributor.authorEdward L. Dreizin
dc.date.accessioned2017-05-09T00:28:54Z
dc.date.available2017-05-09T00:28:54Z
dc.date.copyrightOctober, 2008
dc.date.issued2008
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27845#104505_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/138460
dc.description.abstractThis paper considers the heating and ignition of small metallic particles in hot gases for a range of Knudsen numbers, for which the continuum description of heat transfer is not valid. Modified Fuchs’ model for the transition heat transfer analysis was adapted to treat diatomic gas with properties changing as a function of temperature. The dimensionless heat transfer coefficient, Nusselt number, was calculated as a function of the particle diameter for the transition heat transfer regime. Heat transfer rates in the transition regime are somewhat different from one another for the cases of particle heating and cooling while the absolute values of the particle-gas temperature difference are the same. This effect does not exist for the continuum heat transfer model. It is observed that the applicability of the continuum heat transfer model for particles of different sizes depends on pressure and particle-air temperature difference. For example, for particles at 300K heated in air at 2000K, the continuum heat transfer model can be used for particle diameters greater than 10μm and 1μm at the pressures of 1bar and 10bars, respectively. Transition heat transfer model must be used for the analysis of heat transfer for nanosized particles. For calculating the ignition delay, the continuum model remains useful for particle diameters greater than 18μm and 2μm for 1bar and 10bars, respectively. The sensitivity of the transition heat transfer model to the accommodation coefficient is evaluated. It is found that for metallic particles, the accommodation coefficient has a relatively weak effect on the heat transfer rate.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleHeating and Ignition of Metal Particles in the Transition Heat Transfer Regime
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue10
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2945881
dc.journal.fristpage104505
dc.identifier.eissn1528-8943
dc.keywordsHeat transfer
dc.keywordsParticulate matter
dc.keywordsDelays
dc.keywordsIgnition
dc.keywordsHeating
dc.keywordsTemperature AND Pressure
dc.treeJournal of Heat Transfer:;2008:;volume( 130 ):;issue: 010
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record