| dc.contributor.author | D. Rundström | |
| dc.contributor.author | B. Moshfegh | |
| dc.date.accessioned | 2017-05-09T00:28:47Z | |
| dc.date.available | 2017-05-09T00:28:47Z | |
| dc.date.copyright | December, 2008 | |
| dc.date.issued | 2008 | |
| dc.identifier.issn | 0022-1481 | |
| dc.identifier.other | JHTRAO-27851#121401_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/138396 | |
| dc.description.abstract | The objective of this study is to investigate the thermal performance and the cost measured in pressure drops of a targeted cooling system with use of an impinging jet in combination with a low-velocity channel flow on a heated wall-mounted cube. The effects of the Reynolds numbers of the impinging jet and the cross-flow, as well as the distance between the top and bottom plates, are investigated. A steady-state 3D computational fluid dynamics model was developed with use of a Reynolds stress model as turbulence model. The geometrical case is a channel with a heated cube in the middle of the base plate and two inlets, one horizontal channel flow and one vertical impinging jet. The numerical model was validated against experimental data with a similar geometrical setup. The velocity field was measured by particle image velocimetry and the surface temperature was measured by an infrared imaging system. This case results in a very complex flow structure where several flow-related phenomena influence the heat transfer rate and the pressure drops. The average heat transfer coefficients on each side of the cube and the pressure loss coefficients are presented; correlations for the average heat transfer coefficient on the cube and the pressure loss coefficients are created. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Investigation of Heat Transfer and Pressure Drop of an Impinging Jet in a Cross-Flow for Cooling of a Heated Cube | |
| dc.type | Journal Paper | |
| dc.journal.volume | 130 | |
| dc.journal.issue | 12 | |
| dc.journal.title | Journal of Heat Transfer | |
| dc.identifier.doi | 10.1115/1.2969266 | |
| dc.journal.fristpage | 121401 | |
| dc.identifier.eissn | 1528-8943 | |
| dc.tree | Journal of Heat Transfer:;2008:;volume( 130 ):;issue: 012 | |
| dc.contenttype | Fulltext | |