Show simple item record

dc.contributor.authorL. Westfall
dc.contributor.authorM. A. Singh
dc.contributor.authorS. Saimoto
dc.contributor.authorB. J. Diak
dc.date.accessioned2017-05-09T00:28:13Z
dc.date.available2017-05-09T00:28:13Z
dc.date.copyrightApril, 2008
dc.date.issued2008
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27105#021011_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/138091
dc.description.abstractCrystalline defects other than the essential dislocations are produced by dislocation intersections resulting in debris, which can transform into loops, point defects, and∕or nanovoids. The stress concentrations ahead of slip clusters promote void formation leading to incipient cracks. To evaluate the progression of these processes during deformation, dynamic dislocation-defect analysis was applied to nominally pure aluminum, Al–Mg, and Al–Cu alloys. In the case of nanovoid formation, small angle X-ray scattering (SAXS) was used to quantitatively assess if the void size and its volume fraction can be determined to directly correlate with the measured thermodynamic response values. The SAXS signal from the nanovoids in nominally pure aluminum is distinctly measurable. On the other hand, thermomechanical processing of even nominally pure aluminum results in the formation of nanoprecipitates, which requires future calibration.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDynamic Dislocation-Defect Analysis and SAXS Study of Nanovoid Formation in Aluminum Alloys
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2841619
dc.journal.fristpage21011
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsTemperature
dc.keywordsX-rays
dc.keywordsAluminum
dc.keywordsAluminum alloys
dc.keywordsProduct quality
dc.keywordsStress
dc.keywordsRadiation scattering
dc.keywordsElectromagnetic scattering
dc.keywordsDislocations
dc.keywordsAlloys
dc.keywordsFlow (Dynamics) AND Copper alloys
dc.treeJournal of Engineering Materials and Technology:;2008:;volume( 130 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record