Show simple item record

dc.contributor.authorW. Gan
dc.contributor.authorK. Okamoto
dc.contributor.authorS. Hirano
dc.contributor.authorK. Chung
dc.contributor.authorC. Kim
dc.contributor.authorR. H. Wagoner
dc.date.accessioned2017-05-09T00:28:11Z
dc.date.available2017-05-09T00:28:11Z
dc.date.copyrightJuly, 2008
dc.date.issued2008
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27109#031007_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/138069
dc.description.abstractFriction-stir welding (FSW) promises joints with low porosity, fine microstructures, minimum phase transformation, and low oxidation compared with conventional welding techniques. It is capable of joining combinations of alloys not amenable to conventional welding. Certain combinations of FSW parameters were used to create FSWs of aluminum alloys 5083-H18 and 6111-T4, and the physical weld defects were measured. The mechanical behavior of FSW welds made under the most favorable choice of parameters was determined using tensile tests and hardness measurements and was correlated to the microstructures of the weld and base material. Stir zones (SZs) in the 5083 specimens were much softer than the strain-hardened base materials. SZs in the 6111 material are approximately as hard as the base material. Natural aging of 6111 FSW specimens occurred in some parts of the heat-affected zone and produced hardening for up to 12weeks after welding. Annealing of 5083 FSW specimens produced abnormal grain growth (AGG) for welds produced under certain welding conditions and in certain parts of the weld zone. AGG is more severe for low-heat conditions, i.e., higher tool travel speed but lower rotational speed. The conditions for most favorable FSW are presented, as well as the expected microstructures and mechanical properties, along with the weld conditions that promote AGG.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleProperties of Friction-Stir Welded Aluminum Alloys 6111 and 5083
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2931143
dc.journal.fristpage31007
dc.identifier.eissn1528-8889
dc.keywordsWelding
dc.keywordsWelded joints
dc.keywordsAluminum alloys
dc.keywordsHeat
dc.keywordsTemperature AND Friction
dc.treeJournal of Engineering Materials and Technology:;2008:;volume( 130 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record