Show simple item record

dc.contributor.authorRyan T. Ratliff
dc.contributor.authorPrabhakar R. Pagilla
dc.date.accessioned2017-05-09T00:27:28Z
dc.date.available2017-05-09T00:27:28Z
dc.date.copyrightMarch, 2008
dc.date.issued2008
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26437#021001_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/137699
dc.description.abstractThe feasibility of a ramp load controller using a conventional disk drive actuator is investigated. The controller eliminates the necessity of increased material requirements common in ramp load disk drives. Therefore, disk drives with lower cost, higher performance actuators can realize the linear shock protection benefits of ramp loading. A disk drive designed with a conventional actuator is outfitted with a ramp and optimized for ramp load operation. While on the ramp, there exists a set in the state space where the actuator dynamics are uncontrollable. An input commutation is required within the uncontrollable region to sustain the direction of actuator motion. Additionally, the motor torque factor, magnetic restoration bias, and friction torque are nonlinear and can be represented by functions that are Lipschitz within the actuator ramp angle. A state trajectory is generated that, when tracked, moves the actuator through the uncontrollable set for a successful load onto the disk at the desired load velocity. Because position and velocity information are not available during a load maneuver, an output feedback controller is necessary. A stable, output feedback tracking controller is designed to track the trajectory and handle the nonlinear effects. A unique disk drive is manufactured and experiments are performed to verify the complete ramp loading design strategy.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCommutational Output Feedback Control for Disk Drive Ramp Loading
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue2
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2745853
dc.journal.fristpage21001
dc.identifier.eissn1528-9028
dc.keywordsControl equipment
dc.keywordsStress
dc.keywordsTrajectories (Physics)
dc.keywordsActuators
dc.keywordsDesign
dc.keywordsDisks
dc.keywordsFeedback
dc.keywordsDynamics (Mechanics)
dc.keywordsTorque AND Friction
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2008:;volume( 130 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record