Show simple item record

dc.contributor.authorDaniel Jordy
dc.contributor.authorMohammad I. Younis
dc.date.accessioned2017-05-09T00:27:25Z
dc.date.available2017-05-09T00:27:25Z
dc.date.copyrightJuly, 2008
dc.date.issued2008
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26454#041003_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/137666
dc.description.abstractSqueeze film damping has a significant effect on the dynamic response of microelectromechanical system (MEMS) devices that employ perforated microstructures with large planar areas and small gap widths separating them from the substrate. Perforations can alter the effect of squeeze film damping by allowing the gas underneath the device to easily escape, thereby lowering damping. By decreasing the size of the holes, damping increases and the squeeze film damping effect increases. This can be used to minimize the out-of-plane motion of the microstructures toward the substrate, thereby minimizing the possibility of contact and stiction. This paper aims to explore the use of the squeeze film damping phenomenon as a way to mitigate shock and minimize the possibility of stiction and failure in this class of MEMS devices. As a case study, the performance of a G-sensor (threshold accelerometer) employed in an arming and fusing chip is investigated. The effect of changing the size of the perforation holes and the gap width separating the microstructure from the substrate are studied. A multiphysics finite-element model built using the software ANSYS is utilized for the fluidic and transient structural analysis. A squeeze film damping model, for both the air underneath the structure and the flow of the air through the perforations, is developed. Results are shown for various models of squeeze film damping assuming no holes, large holes, and assuming a finite pressure drop across the holes, which is the most accurate way of modeling. It is found that the threshold of shock that causes the G-sensor to contact the substrate has increased significantly when decreasing the holes size or the gap width, which is very promising to help mitigate stiction in this class of devices, thereby improving their reliability.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCharacterization of the Dynamical Response of a Micromachined G-Sensor to Mechanical Shock Loading
dc.typeJournal Paper
dc.journal.volume130
dc.journal.issue4
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2936849
dc.journal.fristpage41003
dc.identifier.eissn1528-9028
dc.keywordsSensors
dc.keywordsShock (Mechanics)
dc.keywordsDamping
dc.keywordsMicroelectromechanical systems
dc.keywordsStiction AND Motion
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2008:;volume( 130 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record