Show simple item record

dc.contributor.authorDennis K. Williams
dc.contributor.authorTrevor G. Seipp
dc.date.accessioned2017-05-09T00:25:34Z
dc.date.available2017-05-09T00:25:34Z
dc.date.copyrightMay, 2007
dc.date.issued2007
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28481#316_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/136724
dc.description.abstractThis paper describes the considerations employed in the finite element analysis of a relatively “short” support skirt on a hydrocarbon reactor vessel. The analysis is accomplished in accordance with ASME B&PV Code, Section VIII, Division 2 alternate rules in conjunction with the guidelines outlined in WRC Bulletin 429. This provides a sound basis for the classification of the calculated stress intensities. The support skirt is capable of sustaining the deadweight load in addition to resisting the effects of thermal displacements, wind loadings, overturning moments from external piping loads on the attached hydrocarbon reactor vessel, and friction between the skirt base plate and concrete foundation. The displacement and thermal boundary conditions are well defined and discussed in detail. The effects of multiple scenarios for the displacement boundary conditions are examined. The skirt design also employs a hot-box arrangement whereby the primary mode of heat transfer is by radiation. A discussion of the two-part analysis is included and details the interaction between the heat transfer analysis and the subsequent structural analysis. The heat transfer finite element analysis is utilized to determine the temperatures throughout the bottom of the vessel shell and head, as well as the integrally attached support skirt. Of prime importance during the analysis is the axial thermal gradient present in the skirt from the base plate up to and slightly beyond the skirt-to-shell junction. While the geometry of the subject vessel and skirt is best described as axisymmetric, the imposed loadings are a mixture of axisymmetric and non-axisymmetric. This combination lends itself to the judicious selection and utilization of the harmonic finite element and properly chosen Fourier series representation of the applied loads. Comparison of the thermally induced axial stress gradient results from the FEA to those obtained by the closed form beam-on-elastic-foundation are also tendered and discussed. Finally, recommendations are included for the design and analysis of critical support skirts for large, heavy-wall vessels.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleConsiderations in the Design and Analysis of an ASME Section VIII, Div. 2 Reactor Support Skirt
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2722301
dc.journal.fristpage316
dc.journal.lastpage322
dc.identifier.eissn1528-8978
dc.keywordsTemperature
dc.keywordsStress
dc.keywordsDesign
dc.keywordsFinite element analysis
dc.keywordsBoundary-value problems
dc.keywordsShells
dc.keywordsVessels
dc.keywordsForce
dc.keywordsFriction
dc.keywordsFourier series
dc.keywordsJunctions
dc.keywordsWind
dc.keywordsHeat transfer
dc.keywordsPipes
dc.keywordsRadiation (Physics)
dc.keywordsTemperature gradients
dc.keywordsGeometry
dc.keywordsStructural analysis AND Concretes
dc.treeJournal of Pressure Vessel Technology:;2007:;volume( 129 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record