• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Proposed Design Criterion for Vessel Lifting Lugs in Lieu of ASME B30.20

    Thumbnail
    View/Open
    JPVTAS-28481#326_1.pdf (534.8Kb)
    Date
    2007
    Author
    Dennis K. Williams
    Metadata
    Show full item record
    Abstract
    This paper describes a method for evaluating the structural adequacy of various lifting lugs utilized in the erection and up righting of large pressure vessels. In addition, the analysis techniques are described in detail and design guidelines for vessel lifting are tendered. The statutory and provincial regulations in both the United States and the province of Alberta, Canada are also reviewed and discussed with respect to the too often utilized phrase “factor of safety” (FOS). The implied implications derived from the chosen FOS are also outlined. A discussion is presented as to the applicability of the ASME safety standard B30.20 entitled, “Below the Hook Lifting Devices” (1999, ASME, New York) and as to the severe shortcomings of the safety standard in its attempt to delve into the design of lifting devices, especially when applied to lifting lugs on large and heavy-weight pressure vessels. Exemplar lugs on vessels are defined and the finite element analyses and closed form Hertzian contact problem solutions are presented and interpreted in accordance with the proposed design criteria. These results are compared against the very limited design information contained within ASME B30.20. Suggestions for the revision and applicability of the safety standard are presented and discussed in light of the examples and technical justification presented in the following paragraphs. In addition, the silence of this safety standard on the very large contact stresses that are well known to exist between a lifting pin and clevis type geometry is also discussed. Because of the limited number of repetitive loading cycles that vessel lifting lugs actually experience during the service life of a vessel, a recommendation is made to either clearly exclude vessel lifting lugs from the scope of ASME B30.20 or to specifically include a separate design and analysis section within this standard to properly address the mechanical and structural design issues applicable to pressure vessel lifting lugs.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/136704
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV