Show simple item record

dc.contributor.authorR. Adibi-Asl
dc.contributor.authorR. Seshadri
dc.date.accessioned2017-05-09T00:25:30Z
dc.date.available2017-05-09T00:25:30Z
dc.date.copyrightAugust, 2007
dc.date.issued2007
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28483#391_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/136686
dc.description.abstractCracks and flaws occur in mechanical components and structures, and can lead to catastrophic failures. Therefore, integrity assessment of components with defects is carried out. This paper describes the Elastic Modulus Adjustment Procedures (EMAP) employed herein to determine the limit load of components with cracks or crack-like flaw. On the basis of linear elastic Finite Element Analysis (FEA), by specifying spatial variations in the elastic modulus, numerous sets of statically admissible and kinematically admissible distributions can be generated, to obtain lower and upper bounds limit loads. Due to the expected local plastic collapse, the reference volume concept is applied to identify the kinematically active and dead zones in the component. The Reference Volume Method is shown to yield a more accurate prediction of local limit loads. The limit load values are then compared with results obtained from inelastic FEA. The procedures are applied to a practical component with crack in order to verify their effectiveness in analyzing crack geometries. The analysis is then directed to geometries containing multiple cracks and three-dimensional defect in pressurized components.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleLimit Load Analysis of Cracked Components Using the Reference Volume Method
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2749288
dc.journal.fristpage391
dc.journal.lastpage399
dc.identifier.eissn1528-8978
dc.keywordsStress
dc.keywordsFinite element analysis
dc.keywordsStress
dc.keywordsCollapse AND Structures
dc.treeJournal of Pressure Vessel Technology:;2007:;volume( 129 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record