Show simple item record

dc.contributor.authorA. G. Straatman
dc.contributor.authorN. C. Gallego
dc.contributor.authorQ. Yu
dc.contributor.authorL. Betchen
dc.contributor.authorB. E. Thompson
dc.date.accessioned2017-05-09T00:24:39Z
dc.date.available2017-05-09T00:24:39Z
dc.date.copyrightSeptember, 2007
dc.date.issued2007
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27823#1237_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/136230
dc.description.abstractExperiments and computations are presented to quantify the convective heat transfer and the hydraulic loss that is obtained by forcing water through blocks of graphitic foam (GF) heated from one side. Experiments have been conducted in a small-scale water tunnel instrumented to measure the pressure drop and the temperature rise of water passing through the foam and the base temperature and heat flux into the foam block. The experimental data were then used to calibrate a thermal non-equilibrium finite-volume model to facilitate comparisons between GF and aluminum foam. Comparisons of the pressure drop indicate that both normal and compressed aluminum foams are significantly more permeable than GF. Results of the heat transfer indicate that the maximum possible heat dissipation from a given surface is reached using very thin layers of aluminum foam due to the inability of the foam to entrain heat into its internal structure. In contrast, graphitic foam is able to entrain heat deep into the foam structure due to its high extended surface efficiency and thus much more heat can be transferred from a given surface area. The higher extended surface efficiency is mainly due to the combination of moderate porosity and higher solid-phase conductivity.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleForced Convection Heat Transfer and Hydraulic Losses in Graphitic Foam
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue9
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2739621
dc.journal.fristpage1237
dc.journal.lastpage1245
dc.identifier.eissn1528-8943
dc.keywordsFlow (Dynamics)
dc.keywordsHeat
dc.keywordsTemperature
dc.keywordsHeat transfer
dc.keywordsFluids
dc.keywordsFoams (Chemistry)
dc.keywordsAluminum
dc.keywordsConductivity
dc.keywordsPorosity
dc.keywordsPressure drop
dc.keywordsWater
dc.keywordsConvection
dc.keywordsComputer simulation
dc.keywordsForced convection
dc.keywordsEquilibrium (Physics)
dc.keywordsCarbon AND Permeability
dc.treeJournal of Heat Transfer:;2007:;volume( 129 ):;issue: 009
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record