Show simple item record

dc.contributor.authorChaitanya J. Bapat
dc.contributor.authorStefan T. Thynell
dc.date.accessioned2017-05-09T00:24:38Z
dc.date.available2017-05-09T00:24:38Z
dc.date.copyrightSeptember, 2007
dc.date.issued2007
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27823#1109_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/136215
dc.description.abstractThe focus of this work is to study the effects of anisotropic thermal conductivity and thermal contact conductance on the overall temperature distribution inside a fuel cell. The gas-diffusion layers and membrane are expected to possess an anisotropic thermal conductivity, whereas a contact resistance is present between the current collectors and gas-diffusion layers. A two-dimensional single phase model is used to capture transport phenomena inside the cell. From the use of this model, it is predicted that the maximum temperatures inside the cell can be appreciably higher than the operating temperature of the cell. A high value of the in-plane thermal conductivity for the gas-diffusion layers was seen to be essential for achieving smaller temperature gradients. However, the maximum improvement in the heat transfer characteristics of the fuel cell brought about by increasing the in-plane thermal conductivity is limited by the presence of a finite thermal contact conductance at the diffusion layer/current collector interface. This was determined to be even more important for thin gas-diffusion layers. Anisotropic thermal conductivity of the membrane, however, did not have a significant impact on the temperature distribution. The thermal contact conductance at the diffusion layer/current collector interface strongly affected the temperature distribution inside the cell.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleAnisotropic Heat Conduction Effects in Proton-Exchange Membrane Fuel Cells
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue9
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2712478
dc.journal.fristpage1109
dc.journal.lastpage1118
dc.identifier.eissn1528-8943
dc.keywordsFlow (Dynamics)
dc.keywordsHeat
dc.keywordsTemperature
dc.keywordsDiffusion (Physics)
dc.keywordsHeat transfer
dc.keywordsThermal conductivity
dc.keywordsFuel cells
dc.keywordsMembranes
dc.keywordsProton exchange membrane fuel cells
dc.keywordsTemperature distribution
dc.keywordsGas diffusion layers
dc.keywordsContact resistance
dc.keywordsCurrent density
dc.keywordsBoundary-value problems
dc.keywordsCatalysts
dc.keywordsHeat conduction AND Thickness
dc.treeJournal of Heat Transfer:;2007:;volume( 129 ):;issue: 009
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record