Show simple item record

dc.contributor.authorSashidhar S. Panchamgam
dc.contributor.authorJoel L. Plawsky
dc.contributor.authorPeter C. Wayner
dc.date.accessioned2017-05-09T00:24:30Z
dc.date.available2017-05-09T00:24:30Z
dc.date.copyrightNovember, 2007
dc.date.issued2007
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27826#1476_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/136171
dc.description.abstractImage analyzing interferometry was used to study the spreading characteristics of an evaporating octane meniscus (purity: 99+%) on a quartz surface. The thickness, slope, and curvature profiles in the contact line region of the meniscus were obtained using a microscopic data analysis procedure. The results obtained for the octane were compared to that of pure pentane (purity: >99.8%) under similar operating conditions. Isothermal experimental conditions of the menisci were used for the in situ estimation of the retarded dispersion constant. The experimental results for the pure pentane demonstrate that the disjoining pressure (the intermolecular interactions) in the thin-film region controls the fluid flow. Also, an imbalance between the disjoining pressure in the thin-film region and the capillary pressure in the thicker meniscus region resulted in a creeping evaporating pentane meniscus, which spreads over the solid (quartz) surface. On the contrary, for less pure octane, the intermolecular interactions between octane and quartz had a significantly different contribution for fluid flow, and hence, the octane meniscus of lower purity did not creep over the quartz surface. As a result, we had a stationary, evaporating octane meniscus. Using the experimental data and a simple model for the velocity distribution, we evaluated the Marangoni shear in a portion of the stationary, evaporating octane meniscus. An extremely small change in the concentration due to distillation had a significant effect on fluid flow and microscale heat transfer. Also, it was found that nonidealities in small interfacial systems, i.e., the presence of impurities in the working fluid, can have a significant effect on the thickness of the adsorbed film, the heat flux, the spreading characteristics of an almost pure fluid, and, therefore, the assumptions in modeling.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleExperimental Evaluation of Marangoni Shear in the Contact Line Region of an Evaporating 99+% Pure Octane Meniscus
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue11
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2759970
dc.journal.fristpage1476
dc.journal.lastpage1485
dc.identifier.eissn1528-8943
dc.keywordsPressure
dc.keywordsFluids
dc.keywordsShear (Mechanics)
dc.keywordsEvaporation
dc.keywordsThickness
dc.keywordsQuartz
dc.keywordsThin films
dc.keywordsHeat flux
dc.keywordsFluid dynamics
dc.keywordsStress
dc.keywordsFilm thickness AND Vapors
dc.treeJournal of Heat Transfer:;2007:;volume( 129 ):;issue: 011
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record