Show simple item record

dc.contributor.authorChen Li
dc.contributor.authorG. P. Peterson
dc.date.accessioned2017-05-09T00:24:30Z
dc.date.available2017-05-09T00:24:30Z
dc.date.copyrightNovember, 2007
dc.date.issued2007
dc.identifier.issn0022-1481
dc.identifier.otherJHTRAO-27826#1465_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/136170
dc.description.abstractTo better understand the mechanisms that govern the behavior of pool boiling on horizontal highly conductive microporous coated surfaces, a series of experimental investigations were designed to systematically examine the effects of the geometric dimensions (i.e., coating thickness, volumetric porosity, and pore size, as well as the surface conditions of the porous coatings) on the pool-boiling performance and characteristics. The study was conducted using saturated distilled water at atmospheric pressure (101kPa) and porous surfaces fabricated from sintered isotropic copper wire screens. For nucleate boiling on the microporous coated surfaces, two vapor ventilation modes were observed to exist: (i) upward and (ii) mainly from sideways leakage to the unsealed sides and partially from the center of porous surfaces. The ratio of the heater size to the coating thickness, the friction factor of the two-phase flow to single-phase flow inside the porous coatings, as well as the input heat flux all govern the vapor ventilation mode that occurs. In this investigation, the ratio of heater size to coating thickness varies from 3.5 to 38 in order to identify the effect of heater size on the boiling characteristics. The experimental results indicate that the boiling performance and characteristics are also strongly dependent on the volumetric porosity and mesh size, as well as the surface conditions when the heater size is given. Descriptions and discussion of the typical boiling characteristics; the progressive boiling process, from pool nucleate boiling to film boiling; and the boiling performance curves on conductive microporous coated surfaces are all systematically presented.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleParametric Study of Pool Boiling on Horizontal Highly Conductive Microporous Coated Surfaces
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue11
dc.journal.titleJournal of Heat Transfer
dc.identifier.doi10.1115/1.2759969
dc.journal.fristpage1465
dc.journal.lastpage1475
dc.identifier.eissn1528-8943
dc.keywordsBoiling
dc.keywordsThickness
dc.keywordsHeat flux
dc.keywordsVapors
dc.keywordsCoating processes
dc.keywordsPorosity
dc.keywordsPool boiling
dc.keywordsCoatings
dc.keywordsNucleate boiling
dc.keywordsHeat transfer AND Flow (Dynamics)
dc.treeJournal of Heat Transfer:;2007:;volume( 129 ):;issue: 011
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record