Show simple item record

dc.contributor.authorTetsuya Yamaki
dc.contributor.authorJunichi Tsukada
dc.contributor.authorMasaharu Asano
dc.contributor.authorRyoichi Katakai
dc.contributor.authorMasaru Yoshida
dc.date.accessioned2017-05-09T00:24:27Z
dc.date.available2017-05-09T00:24:27Z
dc.date.copyrightFebruary, 2007
dc.date.issued2007
dc.identifier.issn2381-6872
dc.identifier.otherJFCSAU-28928#56_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/136143
dc.description.abstractWe prepared novel ion exchange membranes for possible use in polymer electrolyte fuel cells (PEFCs) by the radiation-induced graft copolymerization of styrene and new crosslinker bis(vinyl phenyl)ethane (BVPE) into crosslinked polytetrafluoroethylene (cPTFE) films and subsequent sulfonation and then investigated their water uptake, proton conductivity, and stability in an oxidizing environment. In contrast to the conventional crosslinker, divinylbenzene (DVB), the degree of grafting of styrene∕BVPE increased in spite of high crosslinker concentrations in the reacting solution (up to 70mol%). Quantitative sulfonation of the aromatic rings in the crosslinked graft chains resulted in the preparation of membranes with a high ion exchange capacity that reached 2.9meq∕g. The bulk properties of the membranes were found to exceed those of Nafion membranes except for chemical stability. The emphasis was on the fact that the BVPE-crosslinked membranes exhibited the higher stability in the H2O2 solution at 60°C compared to the noncrosslinked and DVB-crosslinked ones, as well as decreased water uptake and reasonable proton conductivity. These results are rationalized by considering the reactivity between styrene and the crosslinker, which is an important factor determining the distribution of the crosslinks in the graft component. In the case of BVPE, the crosslinks at a high density were homogeneously incorporated even into the interior of the membrane because of its compatibility with styrene while the far too reactive DVB led to a crosslink formation only near the surface. The combination of both the cPTFE main chain and BVPE-based grafts, i.e., a perfect “double” crosslinking structure, is likely to effectively improve the membrane performances for PEFC applications.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePreparation of Highly Stable Ion Exchange Membranes by Radiation-Induced Graft Copolymerization of Styrene and Bis(vinyl phenyl)ethane Into Crosslinked Polytetrafluoroethylene Films
dc.typeJournal Paper
dc.journal.volume4
dc.journal.issue1
dc.journal.titleJournal of Fuel Cell Science and Technology
dc.identifier.doi10.1115/1.2393305
dc.journal.fristpage56
dc.journal.lastpage64
dc.identifier.eissn2381-6910
dc.keywordsMembranes
dc.keywordsRadiation (Physics)
dc.keywordsWater AND Protons
dc.treeJournal of Fuel Cell Science and Technology:;2007:;volume( 004 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record