Show simple item record

dc.contributor.authorCraig P. Przybyla
dc.contributor.authorBrent L. Adams
dc.contributor.authorMichael P. Miles
dc.date.accessioned2017-05-09T00:23:57Z
dc.date.available2017-05-09T00:23:57Z
dc.date.copyrightJanuary, 2007
dc.date.issued2007
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27092#82_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135873
dc.description.abstractA method is proposed to determine the variance of an arbitrary material property based on the statistics of the texture of polycrystalline materials for a specified volume. This method is applied to determine the variance of the Taylor factor (i.e., measure of plastic deformation in crystal plasticity) and is compared to a random sampling method. The results from the random sampling method correlated well with the statistical variance relationship when the magnitude of the variance was greater than that of the numerical errors observed in the statistical calculation. An empirical relation was also shown to model the results, and the constants for this relationship were determined for pseudo-three-dimensional Fe-3%Si. Implementation of the statistical variance relationship in true three-dimensional microstructures is not limited by material opacity, since it depends only on the two-point pair correlation functions. The connection between the variance of the R-value and variance of the Taylor factor is considered. Although only a weak connection was found, it was observed that relatively small variations in the Taylor factor yield large variances in the R-value.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMethodology for Determining the Variance of the Taylor Factor: Application in Fe-3%Si
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2400268
dc.journal.fristpage82
dc.journal.lastpage93
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsCrystals
dc.keywordsMeasurement
dc.keywordsDimensions
dc.keywordsMaterials properties
dc.keywordsTexture (Materials)
dc.keywordsEngineering simulation
dc.keywordsFunctions
dc.keywordsSampling methods
dc.keywordsStress
dc.keywordsThickness
dc.keywordsErrors
dc.keywordsAnisotropy AND Plasticity
dc.treeJournal of Engineering Materials and Technology:;2007:;volume( 129 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record