Show simple item record

dc.contributor.authorAlexander M. Korsunsky
dc.date.accessioned2017-05-09T00:23:57Z
dc.date.available2017-05-09T00:23:57Z
dc.date.copyrightJanuary, 2007
dc.date.issued2007
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27092#77_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135872
dc.description.abstractAutofrettage is a treatment process that uses plastic deformation to create a state of permanent residual stress within thick-walled tubes by pressurizing them beyond the elastic limit. The present paper presents explicit analytical formulas for residual elastic strains within the tube wall derived on the basis of the classical elastic–ideally plastic solution. Then the problem is addressed of rational interpretation of the radial and hoop residual elastic strains measured at a fixed number of points. To this end, the mismatch between the experimental measurements and theoretical predictions of the residual elastic strains is represented in the form of quadratic functional, J, the minimum of which is sought in terms of the problem parameters, namely, the material yield stress, σY, and the radial position of the elastic-plastic boundary, c. It is shown that J shows an approximately parabolic variation in terms of either parameter when the other is fixed, and that therefore the global minimum of J can be readily found. This procedure is implemented and applied to a set of experimental data on neutron diffraction measurements (2000, J. Strain Anal., 35, pp. 459–469). In conclusion, further applications of this family of interpretation approaches are discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleResidual Elastic Strains in Autofrettaged Tubes: Elastic–Ideally Plastic Model Analysis
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2400267
dc.journal.fristpage77
dc.journal.lastpage81
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsFormulas
dc.keywordsInverse problems
dc.keywordsNeutron diffraction
dc.keywordsYield stress
dc.keywordsAutofrettage
dc.keywordsDeformation
dc.keywordsMeasurement
dc.keywordsPressure AND Residual stresses
dc.treeJournal of Engineering Materials and Technology:;2007:;volume( 129 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record