Show simple item record

dc.contributor.authorC. L. Xie
dc.contributor.authorX. Wu
dc.contributor.authorM. Taya
dc.contributor.authorB. Raju
dc.contributor.authorG. Newaz
dc.contributor.authorM. Hailat
dc.date.accessioned2017-05-09T00:23:57Z
dc.date.available2017-05-09T00:23:57Z
dc.date.copyrightJanuary, 2007
dc.date.issued2007
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27092#69_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135871
dc.description.abstractThe aluminum matrix composite reinforced by short NiTi shape memory alloy fibers, NiTi∕Al6061 composite, was fabricated using pressure-assisted sintering process in ambient air. Surface preparation and thermal pretreatment of NiTi fibers essential for solid state bonding of TixAly intermetallic compound were carried out. Strong interface bonding between NiTi fiber and Al6061 matrix was obtained. The strengthening mechanism of shape memory effect associated with short fiber reinforcement was theoretically examined by extending Taya’s previous model. The stress–strain behavior of the short fiber-reinforced NiTi∕Al6061 composite was investigated at room and elevated temperature both experimentally and analytically. In order to activate the shape memory effect, the composite was prestrained at a temperature between martensite start temperature Ms and austenite start temperature As, then yield stresses as a function of the prestrain were tested and predicted at a temperature above the austenite finish temperature Af. It was found that: (1) the yield stress of the composite increased with increasing the amount of prestrain; (2) the prestrain value should not exceed 0.01, to make use of strengthening of the composite without loss of the ductility of the matrix; and (3) failure of the composite was caused by the strength mismatch between the NiTi fiber and aluminum matrix.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDevelopment of Short Fiber-Reinforced NiTi∕Al6061 Composite
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2400271
dc.journal.fristpage69
dc.journal.lastpage76
dc.identifier.eissn1528-8889
dc.keywordsTemperature
dc.keywordsComposite materials
dc.keywordsFibers
dc.keywordsNickel titanium alloys AND Stress
dc.treeJournal of Engineering Materials and Technology:;2007:;volume( 129 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record