Show simple item record

dc.contributor.authorC. Hari Manoj Simha
dc.contributor.authorJavad Gholipour
dc.contributor.authorAlexander Bardelcik
dc.contributor.authorMichael J. Worswick
dc.date.accessioned2017-05-09T00:23:57Z
dc.date.available2017-05-09T00:23:57Z
dc.date.copyrightJanuary, 2007
dc.date.issued2007
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27092#36_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135867
dc.description.abstractThis paper presents an extended stress-based forming limit curve (XSFLC) that can be used to predict the onset of necking in sheet metal loaded under non-proportional load paths, as well as under three-dimensional stress states. The conventional strain-based ϵFLC is transformed into the stress-based FLC advanced by (1999, Int. J. Mech. Sci., 42, pp. 1–27). This, in turn, is converted into the XSFLC, which is characterized by the two invariants, mean stress and equivalent stress. Assuming that the stress states at the onset of necking under plane stress loading are equivalent to those under three-dimensional loading, the XSFLC is used in conjunction with finite element computations to predict the onset of necking during tubular hydroforming. Hydroforming of straight and pre-bent tubes of EN-AW 5018 aluminum alloy and DP 600 steel are considered. Experiments carried out with these geometries and alloys are described and modeled using finite element computations. These computations, in conjunction with the XSFLC, allow quantitative predictions of necking pressures; and these predictions are found to agree to within 10% of the experimentally obtained necking pressures. The computations also provide a prediction of final failure location with remarkable accuracy. In some cases, the predictions using the XSFLC show some discrepancies when compared with the experimental results, and this paper addresses potential causes for these discrepancies. Potential improvements to the framework of the XSFLC are also discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePrediction of Necking in Tubular Hydroforming Using an Extended Stress-Based Forming Limit Curve
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2400269
dc.journal.fristpage36
dc.journal.lastpage47
dc.identifier.eissn1528-8889
dc.keywordsStress
dc.keywordsNecking
dc.keywordsComputation AND Failure
dc.treeJournal of Engineering Materials and Technology:;2007:;volume( 129 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record