Show simple item record

dc.contributor.authorP. A. Kakavas
dc.contributor.authorG. I. Giannopoulos
dc.contributor.authorN. K. Anifantis
dc.date.accessioned2017-05-09T00:23:57Z
dc.date.available2017-05-09T00:23:57Z
dc.date.copyrightJanuary, 2007
dc.date.issued2007
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27092#11_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135864
dc.description.abstractThis paper presents a mixed finite element formulation approximating large deformations observed in the analysis of elastomeric butt-joints. The rubber has been considered as nearly incompressible continuum obeying the Mooney/Rivlin (M/R) strain energy density function. The parameters of the model were determined by fitting the available from the literature uniaxial tension experimental data with the constitutive equation derived from the M/R model. The optimum value of the Poisson ratio is adjusted by comparing the experimentally observed diametral contraction of the model with that numerically obtained using the finite element method. The solution of the problem has been obtained utilizing the mixed finite element procedure on the basis of displacement/pressure mixed interpolation and enhanced strain energy mixed formulation. For comparison purposes, an axisymmetric with two-parameter M/R model and a three-dimensional (3D) with nine-parameters M/R model of the butt-joint are formulated and numerical results are illustrated concerning axisymmetric or general loading. For small strains the stress and/or strain distribution in the 2D axisymmetric butt-joint problem was compared with derived analytical solutions. Stress distributions along critical paths are evaluated and discussed.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMixed Finite Element Analysis of Elastomeric Butt-Joints
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2400254
dc.journal.fristpage11
dc.journal.lastpage18
dc.identifier.eissn1528-8889
dc.keywordsDeformation
dc.keywordsRubber
dc.keywordsStress
dc.keywordsPoisson ratio
dc.keywordsFinite element analysis
dc.keywordsEquations
dc.keywordsPressure
dc.keywordsFittings
dc.keywordsTension
dc.keywordsFinite element methods
dc.keywordsShear (Mechanics)
dc.keywordsDisplacement
dc.keywordsSteel AND Density
dc.treeJournal of Engineering Materials and Technology:;2007:;volume( 129 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record