Show simple item record

dc.contributor.authorSathyan Subbiah
dc.contributor.authorShreyes N. Melkote
dc.date.accessioned2017-05-09T00:23:56Z
dc.date.available2017-05-09T00:23:56Z
dc.date.copyrightApril, 2007
dc.date.issued2007
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27095#321_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135861
dc.description.abstractOrthogonal cutting experiments using a quick-stop device are performed on Al2024-T3 and OFHC copper to study the chip–workpiece interface in a scanning electron microscope. Evidence of ductile tearing ahead of the tool at cutting speeds of 150m∕min has been found. A numerical finite element model is then developed to study the energy consumed in material separation in micro-cutting. The ductile fracture of Al2024-T3 in a complex stress state ahead of the tool is captured using a damage model. Chip formation is simulated via the use of a sacrificial layer and sequential elemental deletion in this layer. Element deletion is enforced when the accumulated damage exceeds a predetermined value. A Johnson–Cook damage model that is load history dependent and with strain-to-fracture dependent on stress, strain rate, and temperature is used to model the damage. The finite element model is validated using the cutting forces obtained from orthogonal micro-cutting experiments. Simulations are performed over a range of uncut chip thickness values. It is found that at lower uncut chip thickness values, the percentage of energy expended in material separation is higher than at higher uncut chip thicknesses. This work highlights the importance of the energy associated with material separation in the nonlinear scaling effect of specific cutting energy in micro-cutting.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEvidence of Ductile Tearing Ahead of the Cutting Tool and Modeling the Energy Consumed in Material Separation in Micro-Cutting
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2712471
dc.journal.fristpage321
dc.journal.lastpage331
dc.identifier.eissn1528-8889
dc.keywordsSeparation (Technology)
dc.keywordsStress
dc.keywordsCutting
dc.keywordsDuctile fracture
dc.keywordsCutting tools
dc.keywordsComputer simulation
dc.keywordsFinite element model
dc.keywordsFracture (Process)
dc.keywordsForce
dc.keywordsCopper
dc.keywordsModeling
dc.keywordsThickness
dc.keywordsMachining AND Temperature
dc.treeJournal of Engineering Materials and Technology:;2007:;volume( 129 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record