Show simple item record

dc.contributor.authorS. A. Meguid
dc.contributor.authorG. Shagal
dc.contributor.authorJ. C. Stranart
dc.date.accessioned2017-05-09T00:23:56Z
dc.date.available2017-05-09T00:23:56Z
dc.date.copyrightApril, 2007
dc.date.issued2007
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27095#271_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135855
dc.description.abstractIn this paper, we provide two different symmetry cells to describe the shot-peening process. In this multiple impingement model, we study the dynamic behavior of TI-6Al-4V targets subjected to a large number of shots. Three-dimensional elastoplastic finite element analysis (FEA) of the process was conducted using these two symmetry cells for strain-rate sensitive targets and rigid shots. The basic symmetry cell is assigned a target surface area C×C, where C is one half of separation distance between adjacent shots. The second “enhanced” symmetry cell is assigned a target surface area 2C×2C thus allowing higher density of impact point locations. Average residual stresses inside the target predicted by FEA were compared with experimental measurements using the hole-drilling technique. In order to do this, a new averaged technique was developed to obtain the stress distribution inside the symmetry cell. The results reveal that both symmetry cell models could be used for shot-peening modeling. However, the use of the enhanced symmetry cell leads to a better agreement with the measured residual stresses. In addition, the enhanced symmetry cell model allowed us to overcome some of the shortcomings of the basic symmetry cell for cases involving high peening velocity and intensity.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleDevelopment and Validation of Novel FE Models for 3D Analysis of Peening of Strain-Rate Sensitive Materials
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue2
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2712469
dc.journal.fristpage271
dc.journal.lastpage283
dc.identifier.eissn1528-8889
dc.keywordsMeasurement
dc.keywordsResidual stresses
dc.keywordsShot peening
dc.keywordsStress
dc.keywordsFinite element analysis
dc.keywordsFinite element model
dc.keywordsModeling AND Density
dc.treeJournal of Engineering Materials and Technology:;2007:;volume( 129 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record