Show simple item record

dc.contributor.authorT. Schenk
dc.contributor.authorT. Seifert
dc.contributor.authorH. Brehm
dc.date.accessioned2017-05-09T00:23:53Z
dc.date.available2017-05-09T00:23:53Z
dc.date.copyrightJuly, 2007
dc.date.issued2007
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27098#488_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135818
dc.description.abstractCyclic stress-strain measurements have to be performed in order to determine the cyclic plasticity parameters of material models describing the Bauschinger effect. For thin wires, the performance of tensile tests is often not possible due to necking of the specimen on exceeding the yield stress, whereas compression tests are uncritical. This paper presents an approach to determine the cyclic plasticity parameters by performance of compression tests for wires before and after drawing. Here, a simple analogous model is used instead of finite-element (FE) simulations. This approach has been applied for two different integration time steps in order to evaluate their influence on the fit and the accuracy of the integration. It is shown that good accuracy can be obtained for the cyclic plasticity parameters. For FE simulations using larger integration time steps, large deviations have been noted. However, there the analogous model could also be adopted in order to find appropriate model parameters. In general, it is the intention of this paper to show that searching an analogous model can be a very time- and cost-saving task.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Simple Analogous Model for the Determination of Cyclic Plasticity Parameters of Thin Wires to Model Wire Drawing
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2744436
dc.journal.fristpage488
dc.journal.lastpage495
dc.identifier.eissn1528-8889
dc.keywordsWire
dc.keywordsStress
dc.keywordsWire drawing
dc.keywordsEngineering simulation
dc.keywordsFittings
dc.keywordsPlasticity
dc.keywordsCompression
dc.keywordsDeformation AND Hardening
dc.treeJournal of Engineering Materials and Technology:;2007:;volume( 129 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record