Show simple item record

dc.contributor.authorMohamed N.A. Nasr
dc.contributor.authorE.-G. Ng
dc.contributor.authorM. A. Elbestawi
dc.date.accessioned2017-05-09T00:23:52Z
dc.date.available2017-05-09T00:23:52Z
dc.date.copyrightOctober, 2007
dc.date.issued2007
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27101#567_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135812
dc.description.abstractFinite element analysis was used in the current study to examine the effects of strain hardening and initial yield strength of workpiece material on machining-induced residual stresses (RS). An arbitrary–Lagrangian–Eulerian finite element model was built to simulate orthogonal dry cutting with continuous chip formation, then a pure Lagrangian analysis was used to predict the induced RS. The current work was validated by comparing the predicted RS profiles in four workpiece materials to their corresponding experimental profiles obtained under similar cutting conditions. These materials were AISI H13 tool steel, AISI 316L stainless steel, AISI 52100 hardened steel, and AISI 4340 steel. The Johnson–Cook (J–C) constitutive equation was used to model the plastic behavior of the workpiece material. Different values were assigned to the J-C parameters representing the studied properties. Three values were assigned to each of the initial yield strength (A) and strain hardening coefficient (B), and two values were assigned to the strain hardening exponent (n). Therefore, the full test matrix had 18 different materials, covering a wide range of commercial steels. The yield strength and strain hardening properties had opposite effects on RS, where higher A and lower B or n decreased the tendency for surface tensile RS. Because of the opposite effects of A and (B and n), maximum surface tensile RS was induced in the material with minimum A and maximum B and n values. A physical explanation was provided for the effects of A, B, and n on cutting temperatures, strains, and stresses, which was subsequently used to explain their effects on RS. Finally, the current results were used to predict the type of surface RS in different workpiece materials based on their A, B, and n values.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffects of Strain Hardening and Initial Yield Strength on Machining-Induced Residual Stresses
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue4
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2772338
dc.journal.fristpage567
dc.journal.lastpage579
dc.identifier.eissn1528-8889
dc.keywordsTemperature
dc.keywordsMachining
dc.keywordsStress
dc.keywordsCutting
dc.keywordsWork hardening
dc.keywordsYield strength
dc.keywordsResidual stresses
dc.keywordsModeling AND Finite element analysis
dc.treeJournal of Engineering Materials and Technology:;2007:;volume( 129 ):;issue: 004
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record