• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Modeling of Elastic Waves in Dynamically Loaded NiAl Bicrystals

    Thumbnail
    View/Open
    JEMTA8-27101#513_1.pdf (948.9Kb)
    Date
    2007
    Author
    Eric Loomis
    Pedro Peralta
    Damian C. Swift
    Metadata
    Show full item record
    Abstract
    Two methods have been used to simulate 2D elastic wave scattering in nickel aluminide (NiAl) bicrystals to study effects of grain boundaries and material anisotropy on elastic wave propagation. Scattering angles and amplitude ratios of the reflected and refracted waves produced at the grain boundary were calculated via slowness curves for both grains, which were plotted in the plane of incidence containing the grain boundary normal. From these curves, scattering angles were measured graphically and amplitude ratios were calculated based on the continuity of tractions and displacements at the boundary. To support these calculations, finite element simulations were performed with ABAQUS /EXPLICIT to obtain time- and space-dependent stresses. The results of each method correlated well with each other for four bicrystals. It was found that for bicrystals where the transmitted quasi-longitudinal (TQL) wave amplitude decreased across the boundary, diminished stresses were found in the finite element models for the same bicrystal. Conversely, where an increase in amplitude of the TQL wave was found, the finite element simulations showed that stress under the boundary increased. In general, the amplitude of the TQL wave was found to have a strong connection to the ratio of incident and TQL sound speeds. However, other directions in each grain are believed to contribute strongly to the overall scattering process since the pairs of bicrystals in this investigation had somewhat similar sound speeds. These findings correlated well with free surface cracking observed in a previous paper (, , , and , 2005, Mater. Sci. Eng., Ser. A., 404(1-2), pp. 291–300), where cracks nucleated and propagated due to the focusing of scattered waves at the boundary. Specifically, in bicrystals oriented for shielding, the grain boundary was protected forcing cracks to grow outside of the shielded region.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/135805
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV