Show simple item record

dc.contributor.authorLubomir A. Ribarov
dc.contributor.authorDavid S. Liscinsky
dc.date.accessioned2017-05-09T00:23:32Z
dc.date.available2017-05-09T00:23:32Z
dc.date.copyrightMarch, 2007
dc.date.issued2007
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26542#71_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135636
dc.description.abstractCooling, heating, and power (CHP) energy systems provide higher fuel efficiency than conventional systems, resulting in reduced fuel consumption, reduced emissions, and other environmental benefits. Until recently the focus of CHP system development has been primarily on medium-scale commercial applications in a limited number of market segments where clear value propositions lead to short term payback. Small-scale integrated CHP systems that show promise of achieving economic viability through significant improvements in fuel utilization have received increased attention lately. In this paper the economic potential is quantified for small-scale (microgrid) integrated CHP systems suitable for groups of buildings with aggregate electric loads in the 15–120kW range. Technologies are evaluated for community building groups (CBGs) consisting of aggregation of pure residential entities and combined residential and light commercial entities. Emphasis is on determination of the minimum load size (i.e., the smallest electric and thermal load for a given CBG that is supplied with electric, heating, cooling power from a CHP) for which a microgrid CHP system is both technically and economically viable. In this paper, the operation of the CHP system is parallel with the public utility grid at all times, i.e., the grid is interconnected. Evaluations of CHP technology options using simulation studies in a “three-dimensional” space (CHP technology option, CBG load aggregation, and geographical location in the USA) were evaluated based on comparisons of net present value (NPV). The simulations indicated that as electric load increases, the viability of the CHP system (independent of the system’s size) becomes more favorable. Exceeding a system runtime (utilization) of 70% was shown to pass the break-even line in the NPV analysis. Finally, geographic location was found to have a relatively weak effect on the reported trends. These results suggest that microgrid CHP systems have the potential to be economically viable with relative independence of geographic location if adequately sized to match the specific load requirements.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMicrogrid Viability for Small-Scale Cooling, Heating, and Power
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue1
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2424967
dc.journal.fristpage71
dc.journal.lastpage78
dc.identifier.eissn1528-8994
dc.keywordsCooling
dc.keywordsCombined heat and power
dc.keywordsMicrogrids
dc.keywordsHeating AND Stress
dc.treeJournal of Energy Resources Technology:;2007:;volume( 129 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record