Show simple item record

dc.contributor.authorN. Hegde
dc.contributor.authorI. Han
dc.contributor.authorT. W. Lee
dc.contributor.authorR. P. Roy
dc.date.accessioned2017-05-09T00:23:31Z
dc.date.available2017-05-09T00:23:31Z
dc.date.copyrightSeptember, 2007
dc.date.issued2007
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26547#232_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/135617
dc.description.abstractComputational simulations of flow and heat transfer in heat recovery steam generators (HRSGs) of vertical- and horizontal-tube designs are reported. The main objective of the work was to obtain simple modifications of their internal configuration that render the flow of combustion gas more spatially uniform. The computational method was validated by comparing some of the simulation results for a scaled-down laboratory model with experimental measurements in the same. Simulations were then carried out for two plant HRSGs—without and with the proposed modifications. The results show significantly more uniform combustion gas flow in the modified configurations. Heat transfer calculations were performed for one superheater section of the vertical-tube HRSG to determine the effect of the configuration modification on heat transfer from the combustion gas to the steam flowing in the superheater tubes.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFlow and Heat Transfer in Heat Recovery Steam Generators
dc.typeJournal Paper
dc.journal.volume129
dc.journal.issue3
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2751505
dc.journal.fristpage232
dc.journal.lastpage242
dc.identifier.eissn1528-8994
dc.keywordsFlow (Dynamics)
dc.keywordsHeat recovery steam generators
dc.keywordsHeat transfer
dc.keywordsCombustion gases AND Simulation
dc.treeJournal of Energy Resources Technology:;2007:;volume( 129 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record