• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Modeling of Chemical Processes in a Diesel Engine With Alcohol Fuels

    Thumbnail
    View/Open
    JERTD2-26548#355_1.pdf (535.2Kb)
    Date
    2007
    Author
    Nadir Yilmaz
    A. Burl Donaldson
    Metadata
    Show full item record
    Abstract
    Methanol utilization in a compression ignition engine has held tentative promise for a number of years, and, in fact, the concept has seen large scale field trials intended to demonstrate this option as a precursor to commercial implementation. However, results from those tests have identified some of the practical problems encountered with this fuel, namely, (1) its difficulty of vaporization and (2) its high autoignition temperature. Luminosity promoting additives, which facilitate radiative transport as a component of flame spread (because pure alcohol burns with little luminosity, continuum radiation as a reaction transport mechanism is essentially absent), intake air heating, active and passive heat sources, etc., represent some of the attempts to overcome limitations of these two factors. Except for intake air preheat, these augmentation methods have been noted to result in poor off-load thermal cycle efficiency. Focusing on the case of intake air preheat (which can be achieved by elevated compression ratio), and to model the chemical reaction kinetics, the partially stirred reactor model in CHEMKIN was used. This approach provided examination of the chemistry and reaction rates associated with an actual trial in which methanol was the fuel under study. To initiate this simulation, literature available reaction mechanisms were obtained, and then the experimental cylinder pressure history was matched by control of heat release rate via the partially stirred reactor model. This is represented within the reactor model by changing the turbulent mixing intensity factor. The overall reaction sequence, which models cylinder pressure, and attendant extent of reaction were the major focus. The minor focus included production of emission gases, e.g., the aldehydes and unburned fuel. Not only are the model results consistent with actual findings, they also support a method for addressing causes of off-load inefficiency and engine failures due to engine oil dilution with fuel.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/135606
    Collections
    • Journal of Energy Resources Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV