Show simple item record

dc.contributor.authorDonald Mackenzie
dc.contributor.authorHongjun Li
dc.date.accessioned2017-05-09T00:21:26Z
dc.date.available2017-05-09T00:21:26Z
dc.date.copyrightFebruary, 2006
dc.date.issued2006
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28463#39_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/134551
dc.description.abstractThe allowable plastic load in pressure vessel design by analysis is determined by applying a graphical construction to a characteristic load-deformation plot of the collapse behavior of the vessel. This paper presents an alternative approach to the problem. The plastic response is characterized by considering the curvature of a plot of plastic work dissipated in the vessel against the applied load. It is proposed that salient points of curvature correspond to critical stages in the evolution of the gross plastic deformation mechanism. In the proposed plastic work curvature (PWC) criterion of plastic collapse, the plastic load is defined as the load corresponding to zero or minimal plastic work curvature after yielding and the formation of plastic mechanisms have occurred. Application of the proposed criterion is illustrated by considering the elastic-plastic response of a simple cantilever beam in bending and a complex three-dimensional finite element analysis of a nozzle intersection. The results show that the proposed approach gives higher values of plastic load than alternative criteria when the material exhibits strain hardening. It is proposed that this is because the PWC criterion more fully represents the constraining effect of material strain hardening on the spread of plastic deformation.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleA Plastic Load Criterion for Inelastic Design by Analysis
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2137768
dc.journal.fristpage39
dc.journal.lastpage45
dc.identifier.eissn1528-8978
dc.keywordsDeformation
dc.keywordsStress
dc.keywordsDesign AND Intersections
dc.treeJournal of Pressure Vessel Technology:;2006:;volume( 128 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record