Show simple item record

dc.contributor.authorGerry C. Slagis
dc.date.accessioned2017-05-09T00:21:26Z
dc.date.available2017-05-09T00:21:26Z
dc.date.copyrightFebruary, 2006
dc.date.issued2006
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28463#8_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/134547
dc.description.abstractThe ASME Section III Design-by-Analysis rules for pressure-retaining components include a detailed fatigue evaluation based on elastically predicted primary, secondary, and peak stresses. A prerequisite for the fatigue analysis is that the primary-plus-secondary stress range does not exceed 3Sm. If this limit is exceeded, the code provides “Simplified Elastic-Plastic Analysis” rules for the fatigue evaluation. A Ke penalty factor is applied to the elastically predicted alternating stress. The maximum value of Ke (3.3 or 5) is a severe design limitation. Test data indicate that the code specified maximum value of Ke is very conservative. The simplified elastic-plastic rules were originally developed for piping and published in B31.7. When the piping rules were incorporated into Section III in 1971, the B31.7 procedure was replaced by a less complex procedure. The development of the simplified elastic-plastic analysis approach is reviewed to establish the technical basis for the present code rules. The concepts of fatigue, shakedown to elastic action, thermal bending, elastic follow-up, notch factor, and strain redistribution are discussed. Recommendations for changes to the plastic strain correction factor are provided.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMeaning of Ke in Design-by-Analysis Fatigue Evaluation
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2140798
dc.journal.fristpage8
dc.journal.lastpage16
dc.identifier.eissn1528-8978
dc.keywordsFatigue
dc.keywordsStress
dc.keywordsDesign
dc.keywordsPipes
dc.keywordsFatigue analysis
dc.keywordsCycles AND Stress concentration
dc.treeJournal of Pressure Vessel Technology:;2006:;volume( 128 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record