Show simple item record

dc.contributor.authorAndrew Littlefield
dc.contributor.authorRobert Langone
dc.contributor.authorRobert Becker
dc.contributor.authorEdward Hyland
dc.contributor.authorAndrew Andalora
dc.contributor.authorNathaniel Klein
dc.date.accessioned2017-05-09T00:21:25Z
dc.date.available2017-05-09T00:21:25Z
dc.date.copyrightMay, 2006
dc.date.issued2006
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28467#257_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/134539
dc.description.abstractThe emphasis on lightweight large-caliber weapons systems has placed the focus on the use of advanced composite materials. Using composite materials not only directly removes weight from the gun tube but, by better balancing the tube, allows the use of smaller gun stabilization drive systems, thus further enhancing system weight loss. Additionally, the use of high stiffness composites helps with pointing accuracy and alleviating the dynamic strain phenomenon encountered with high-velocity projectiles. Traditionally though, using composites has been difficult because of the coefficient of thermal expansion mismatch between the steel substrate and the composite jacket, which causes a gap after manufacturing. Dealing with this mismatch has greatly complicated the manufacturing process in the past to the point where mass-producing the barrels would be problematic at best. By using a thermoplastic resin and a cure on the fly process, the manufacturability of the barrels has been greatly improved and the gap has been eliminated. This is the first time that this approach has been applied to a large-caliber gun tube. A 120mm barrel has been manufactured using this process with IM7 fibers in a polyetheretherketone matrix and successfully test fired. This paper will present the design, manufacturing, and test firing of this barrel.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleCarbon Fiber/Thermoplastic Overwrapped Gun Tube
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2172958
dc.journal.fristpage257
dc.journal.lastpage262
dc.identifier.eissn1528-8978
dc.keywordsComposite materials
dc.keywordsSteel
dc.keywordsFiring (materials)
dc.keywordsGun barrels
dc.keywordsManufacturing
dc.keywordsFibers
dc.keywordsCarbon fibers
dc.keywordsPressure AND Design
dc.treeJournal of Pressure Vessel Technology:;2006:;volume( 128 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record