• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Pressure Vessel Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Assembly of Compound Tubes Under Hydraulic Pressure

    Thumbnail
    View/Open
    JPVTAS-28467#208_1.pdf (426.5Kb)
    Date
    2006
    Author
    Tony D. Andrews
    Metadata
    Show full item record
    Abstract
    This paper describes a method for inserting a tapered liner into a sleeve while the latter is expanded by hydraulic pressure. The technique avoids many of the limitations associated with traditional shrink fit techniques and autofrettage. The sleeve and liner are manufactured with internal and external tapers, respectively, to give the appropriate interference for the finished compound tube. The liner is mounted on a rod and positioned loosely inside the sleeve. The ends of the sleeve are sealed with plugs, which allow the rod to protrude through each end and which also have hydraulic oil inlets. Once the assembly has been pressurized, the rod is pushed into the vessel to move the liner further into the sleeve generating an interference once the pressure in the sleeve is removed. Insertion of a relatively thin liner can generate high residual compressive stresses at the bore, similar to autofrettage but with a shallower gradient away from the bore. Because the liner is not subjected to plastic strain during manufacture, there is no reduction in compressive strength due to the Bauschinger effect and the maximum compressive stress obtainable is greater than that from traditional autofrettage routes. Such high stresses lead to excess tension in the sleeve, which must be reduced by autofrettaging the sleeve prior to assembly of the compound tube. Such a configuration is suitable for inserting a part-length liner at the chamber for strength and/or wear resistance and tensile stresses can be eliminated to prevent failure of brittle materials, such as ceramics.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/134529
    Collections
    • Journal of Pressure Vessel Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV