Show simple item record

dc.contributor.authorEliseu L. Monteiro
dc.contributor.authorAbel I. Rouboa
dc.contributor.authorAntónio A. C. Monteiro
dc.date.accessioned2017-05-09T00:21:23Z
dc.date.available2017-05-09T00:21:23Z
dc.date.copyrightAugust, 2006
dc.date.issued2006
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28470#462_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/134515
dc.description.abstractThe production of a part by foundry techniques is influenced by its complex geometry configuration, which affects the solidification conditions and subsequent cooling. For example certain pipes, some vessels and most valves are produced by casting. To model the solidification of the complex shapes such as valves is difficult if Cartesian coordinates are used. Even simpler parts like pipes may become difficult to model because they usually are not orthogonally ruled shapes. The main objective of this paper is to describe the development of a finite volume method intended to simulate the heat transfer phenomena during the phase change process. Because of the mold design complexity, the finite volume is described using the generalized curvilinear formulation.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleHeat Transfer Simulation in the Mold With Generalized Curvilinear Formulation
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2218352
dc.journal.fristpage462
dc.journal.lastpage466
dc.identifier.eissn1528-8978
dc.keywordsTemperature
dc.keywordsHeat transfer
dc.keywordsSimulation
dc.keywordsSolidification
dc.keywordsFinite volume methods
dc.keywordsEquations
dc.keywordsCasting
dc.keywordsMetals
dc.keywordsShapes
dc.keywordsPipes
dc.keywordsCooling AND Geometry
dc.treeJournal of Pressure Vessel Technology:;2006:;volume( 128 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record