Show simple item record

dc.contributor.authorR. P. Paranhos
dc.contributor.authorI. S. Bott
dc.contributor.authorR. Rosenthal
dc.date.accessioned2017-05-09T00:21:20Z
dc.date.available2017-05-09T00:21:20Z
dc.date.copyrightAugust, 2006
dc.date.issued2006
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28470#314_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/134492
dc.description.abstractA neutral flux and four different wires were used to produce all weld metal submerged-arc multipass welds. Impact Charpy V transition curves were obtained from two testing series, each with a different notch position along the welded joint. The results show that, according to the notch position, distinct fractions of weld metal columnar and reheated regions are present at the notch tip. Impact toughness of the weld metal with predominance of reheated regions is always superior to that with predominance of columnar region. Modification of some of the ASME II Part C standards relating to the specification of welding consumables is recommended for improved consistency with ASME VIII code for boiler and pressure vessel fabrication.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEffect of Charpy V Notch Position on Impact Toughness of all Weld Metal Welds and its Relevance With ASME Codes
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2217963
dc.journal.fristpage314
dc.journal.lastpage317
dc.identifier.eissn1528-8978
dc.keywordsMetals
dc.keywordsWelded joints
dc.keywordsToughness
dc.keywordsWelding
dc.keywordsASME Standards AND Wire
dc.treeJournal of Pressure Vessel Technology:;2006:;volume( 128 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record