Show simple item record

dc.contributor.authorH. J. Rathbun
dc.contributor.authorG. R. Odette
dc.contributor.authorT. Yamamoto
dc.contributor.authorM. Y. He
dc.contributor.authorG. E. Lucas
dc.date.accessioned2017-05-09T00:21:20Z
dc.date.available2017-05-09T00:21:20Z
dc.date.copyrightAugust, 2006
dc.date.issued2006
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28470#305_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/134491
dc.description.abstractA systematic investigation of the effects of specimen size on the cleavage fracture toughness of a typical pressure vessel steel is reported. Size dependence arises both from: (i) statistical effects, related to the volume of highly stressed material near the crack tip, that scales with the crack front length (B) and (ii) constraint loss, primarily associated with the scale of plastic deformation compared to the un-cracked ligament dimension (b). Previously, it has been difficult to quantify the individual contributions of statistical versus constraint loss size effects. Thus, we developed a single variable database for a plate section from the Shoreham pressure vessel using a full matrix of three point bend specimens, with B from 8 to 254 mm and b from 3.2 to 25.4 mm, that were tested at a common set of conditions. The University of California Santa Barbara (UCSB) b-B database was analyzed using three-dimensional finite element calculation of the crack tip fields combined with a cleavage model calibrated to the local fracture properties of the Shoreham steel. This paper focuses on the possible significance of these results to the Master Curve standard as formulated in ASTM E 1921. The statistical scaling procedure to treat variations in B used in E 1921 was found to be reasonably consistent with the UCSB b-B database. However, constraint loss for three point bend specimens begins at a deformation level that is much lower than the censoring limit specified in E 1921. Unrecognized constraint loss leads to a nonconservative, negative bias in the evaluation of To, estimated to be typically on the order of −10°C for pre-cracked Charpy specimens.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleStatistical and Constraint Loss Size Effects on Cleavage Fracture–Implications to Measuring Toughness in the Transition
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.2217962
dc.journal.fristpage305
dc.journal.lastpage313
dc.identifier.eissn1528-8978
dc.keywordsSteel
dc.keywordsFracture (Process)
dc.keywordsDatabases
dc.keywordsGeometry
dc.keywordsToughness
dc.keywordsASTM International
dc.keywordsDeformation
dc.keywordsStress
dc.keywordsThickness
dc.keywordsFinite element analysis
dc.keywordsDimensions AND Fracture toughness
dc.treeJournal of Pressure Vessel Technology:;2006:;volume( 128 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record