• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Engineering Materials and Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Buckling Analysis of Delaminated and Stitched Composite Plate System Under Hygrothermal Pressure

    Thumbnail
    View/Open
    JEMTA8-27078#117_1.pdf (630.0Kb)
    Date
    2006
    Author
    S. Leigh Phoenix
    Katerina D. Papoulia
    C. Yuen Hui
    A. Kadir Yavuz
    Metadata
    Show full item record
    Abstract
    In this study, we develop a model for buckling of a partially delaminated composite plate with transverse stitching to resist out of plane deformations. The model applies to carbon fiber/polyimide matrix composites rapidly heated to around 370 °C, where it is known that steam-induced delamination (the popcorn effect) becomes an issue as the pressures generated approach the tensile strength of the matrix. Thus, a key element is the incorporation of this hygrothermal pressure within the formulation. This complex composite structure is modeled as two adhesively connected, specially orthotropic, rectangular plates, and the delaminations with internal vapor pressure are considered as holes in the adhesive layer. The intact regions of the adhesive layer and the stitches are modeled by continuous and discrete linear mechanical springs, respectively. The energy contributions of each component in the system are expressed in terms of out-of-plane displacements. The boundary conditions are that the system is simply supported along all edges so as to permit a Fourier sine series to approximate the transverse displacements. Application of the energy minimization approach gives a system of algebraic equations to determine the unknown weighting coefficients of the functions describing the transverse deflections of each plate layer. Deformed shapes of the system under axial compressive loads are obtained for different hygrothermally induced pressure conditions so as to show that the model works well. Parametric studies on critical buckling loads are performed for a few stitch and delamination configurations. It is found that stitching through delaminated areas can increase critical buckling loads and alter the sequence of corresponding mode shapes.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/133827
    Collections
    • Journal of Engineering Materials and Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV