Show simple item record

dc.contributor.authorA. H. Mahmoudi
dc.contributor.authorD. Stefanescu
dc.contributor.authorS. Hossain
dc.contributor.authorP. J. Withers
dc.contributor.authorC. E. Truman
dc.contributor.authorD. J. Smith
dc.date.accessioned2017-05-09T00:20:02Z
dc.date.available2017-05-09T00:20:02Z
dc.date.copyrightJuly, 2006
dc.date.issued2006
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27084#451_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/133777
dc.description.abstractSide-punching is proposed as a method of introducing a well-defined residual stress field into a laboratory-sized test specimen. Such a specimen may subsequently be used to assess the influence of residual stresses on the fracture behavior of materials. Side-punching consists of simultaneously indenting opposite faces of a plate of material with rigid tools, using sufficient force to cause localized yielding over a finite-sized volume of material adjacent to the punching tools. This paper presents experimental measurements, obtained using three independent measurement techniques, of the residual stress field generated in an aluminium alloy plate after side-punching. Incremental center hole drilling is used to determine the near-surface residual stress field, while synchrotron x-ray diffraction and deep hole drilling are used to measure the through-thickness residual stress field along a path linking the two punch center points. Finite element (FE) predictions are also presented and compared to the measurements. There is very good agreement between all three sets of measurements and the FE results, which all show that the through-thickness residual stresses are compressive and attain a maximum value at the center of the plate. The results confirm the potential use of side-punching in residual stress-crack interaction studies.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleMeasurement and Prediction of the Residual Stress Field Generated by Side-Punching
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2203103
dc.journal.fristpage451
dc.journal.lastpage459
dc.identifier.eissn1528-8889
dc.keywordsDrilling
dc.keywordsResidual stresses
dc.keywordsStress
dc.keywordsPunching (Metalworking)
dc.keywordsMeasurement
dc.keywordsFinite element analysis
dc.keywordsThickness AND Aluminum alloys
dc.treeJournal of Engineering Materials and Technology:;2006:;volume( 128 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record