Show simple item record

dc.contributor.authorW. Polini
dc.contributor.authorL. Sorrentino
dc.date.accessioned2017-05-09T00:20:01Z
dc.date.available2017-05-09T00:20:01Z
dc.date.copyrightJuly, 2006
dc.date.issued2006
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27084#393_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/133771
dc.description.abstractRobotized filament winding technology allows one to manufacture workpieces of high performances as a result of a robot placing fibers impregnated by resin (known as roving) along the directions of stresses the workpiece is subjected to in exercise; thus, robotized filament winding favors rigidity and strength of a workpiece along some preferential directions. A proper value of the winding tension has to be chosen and kept constant along the whole winding in order to limit the defects inside the composite workpieces. To keep the tension value on roving near to the nominal value, one must plan the value of the geometric parameters characterizing the winding trajectory. The same geometric parameters influence the value of the actual safety distance that may involve collisions among the deposition system and the components of the robotized cell. This work shows how to avoid the occurrence of collisions by planning the value of the actual safety distance through the definition of geometric parameters that characterize the winding trajectory. Moreover, the collision occurrence should be considered together with the control of the winding tension on the roving in the robotized filament winding planning stage. The present work shows how to solve both the problems previously defined (i.e., to keep the winding tension on roving near to the nominal value and to avoid collision occurrence), by the solution of a constrained optimization system.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleActual Safety Distance and Winding Tension to Manufacture Full Section Parts by Robotized Filament Winding
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue3
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.2203099
dc.journal.fristpage393
dc.journal.lastpage400
dc.identifier.eissn1528-8889
dc.keywordsSafety
dc.keywordsTrajectories (Physics)
dc.keywordsTension AND Winding (process)
dc.treeJournal of Engineering Materials and Technology:;2006:;volume( 128 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record