• Login
    View Item 
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    •   DSpace Home
    • ASME
    • Journal of Energy Resources Technology
    • View Item
    JavaScript is disabled for your browser. Some features of this site may not work without it.

    Flow Regime Study of a Light Material in an Industrial Scale Cold Flow Circulating Fluidized Bed

    Thumbnail
    View/Open
    JERTD2-26536#129_1.pdf (304.9Kb)
    Date
    2006
    Author
    Joseph S. Mei
    Esmail R. Monazam
    Lawrence J. Shadle
    Metadata
    Show full item record
    Abstract
    A series of experiments was conducted in the 0.3meter diameter circulating fluidized bed test facility at the National Energy Technology Laboratory (NETL) of the U. S. Department of Energy. The particle used in this study was a coarse, light material, cork, which has a particle density of 189kg∕m3 and a mean diameter of 812μm. Fluidizing this material in ambient air approximates the same gas-solids density ratio as coal and coal char in a pressurized gasifier. The purpose of this study is twofold. First, this study is to provide a better understanding on the fundamentals of flow regimes and their transitions. The second purpose of this study is to generate reliable data to validate the mathematical models, which are currently under development at NETL. Utilization of such coarse, light material can greatly facilitate the computation of these mathematical models. Furthermore, the ratio of density of cork to air under ambient conditions is similar to the density ratio of coal to gas at the gasification and pressurized fluidized bed combustion environment. This paper presents and discusses the data, which covered operating flow regime from dilute phase, fast fluidization, and to dense phase transport by varying the solid flux, Gs at a constant gas velocity, Ug. Data are presented by mapping the flow regime for coarse cork particles in a ΔP∕ΔL‐Gs‐Ug plot. The coarse cork particles exhibited different behavior than the published literature measurements on heavier materials such as alumina, sand, FCC, silica gel, etc. A stable operation can be obtained at a fixed riser gas velocity higher than the transport velocity, e.g., at Ug=3.2m∕s, even though the riser is operated within the fast fluidization flow regime. Depending upon the solids influx, the riser can also be operated at dilute phase or dense phase flow regimes. Experimental data were compared to empirical correlations in published literature for flow regime boundaries as well as solids fractions in the upper dilute and the lower dense regions for fast fluidization flow regime. Comparisons of measured data with these empirical correlations show rather poor agreements. These discrepancies, however, are not surprising since the correlations for these transitions were derived from experimental data of comparative heavier materials such as sands, FCC, iron ore, alumina, etc.
    URI
    http://yetl.yabesh.ir/yetl/handle/yetl/133599
    Collections
    • Journal of Energy Resources Technology

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV
     

     

    Browse

    All of DSpaceCommunities & CollectionsBy Issue DateAuthorsTitlesSubjectsThis CollectionBy Issue DateAuthorsTitlesSubjects

    My Account

    LoginRegister

    Statistics

    View Usage Statistics

    DSpace software copyright © 2002-2015  DuraSpace
    Contact Us | Send Feedback
    Theme by 
    @mire NV