Show simple item record

dc.contributor.authorI. Gulyurtlu
dc.contributor.authorP. Abelha
dc.contributor.authorD. Boavida
dc.contributor.authorJ. Seabra
dc.contributor.authorS. Gomes
dc.contributor.authorN. Chaleta
dc.contributor.authorI. Cabrita
dc.date.accessioned2017-05-09T00:19:41Z
dc.date.available2017-05-09T00:19:41Z
dc.date.copyrightJune, 2006
dc.date.issued2006
dc.identifier.issn0195-0738
dc.identifier.otherJERTD2-26536#118_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/133597
dc.description.abstractA mixture involving wood, plastics, paper, and textile materials was burned in a fluidized bed combustor to monitor the gaseous emissions and to analyze the ashes collected in different locations of the installation. The ashes collected were first analyzed to verify the partitioning of heavy metals in different ash streams. They were then subjected to leaching tests to verify the solubility of different components present. There is a growing interest in utilizing wastes, which cannot be recycled for further use, for energy, particularly in Europe as the amounts are great and the cost of depositing them in landfills has become very considerable. These wastes are considered renewable sources and the recent policy is to encourage their use for energy, especially for decentralized energy production. However, these wastes may be contaminated and have to be verified that their utilization for energy does not bring about any adverse consequences on the environment. Each component making up the blend to be used as fuel needs to be analyzed to determine not only its composition but also its heating value so that the final blend to be prepared could present minimum risk for emissions of pollutants, ideally less than coal and with a heating value comparable, at least, to that of coal. The results obtained suggest that (i) the combustion efficiency was very high, (ii) there was an enrichment of ashes with heavy metals in the cyclones compared to the bed material, (iii) the gaseous pollutants were below the permitted limits, and (iv) the ashes did not have tendency for leaching. Such mixtures could, therefore, be used as a solid fuel in industry as a substitution for coal or heavy fuel oil.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Implications of Burning a Blend of Waste Materials in a Fluidizied Bed Combustor
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue2
dc.journal.titleJournal of Energy Resources Technology
dc.identifier.doi10.1115/1.2191504
dc.journal.fristpage118
dc.journal.lastpage122
dc.identifier.eissn1528-8994
dc.keywordsCombustion
dc.keywordsFuels
dc.keywordsCombustion chambers
dc.keywordsEmissions
dc.keywordsAsh
dc.keywordsCoal
dc.keywordsHeavy metals
dc.keywordsPollution
dc.keywordsParticulate matter
dc.keywordsWood products
dc.keywordsFluidized beds AND Textiles
dc.treeJournal of Energy Resources Technology:;2006:;volume( 128 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record