Show simple item record

dc.contributor.authorSeung Kook Jun
dc.contributor.authorGlenn D. White
dc.contributor.authorVenkat N. Krovi
dc.date.accessioned2017-05-09T00:19:30Z
dc.date.available2017-05-09T00:19:30Z
dc.date.copyrightMarch, 2006
dc.date.issued2006
dc.identifier.issn0022-0434
dc.identifier.otherJDSMAA-26351#112_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/133485
dc.description.abstractOur long-term goal is one of designing land-based vehicles to provide enhanced uneven-terrain locomotion capabilities. In this paper, we examine and evaluate candidate articulated leg-wheel subsystem designs for use in such vehicle systems. The leg-wheel subsystem designs under consideration consist of disk wheels attached to the chassis through an articulated linkage containing multiple lower-pair joints. Our emphasis is on creating a design that permits the greatest motion flexibility between the chassis and wheel while maintaining the smallest degree-of-freedom (DOF) within the articulated chain. We focus our attention on achieving two goals: (i) obtaining adequate ground clearance by designing the desired/feasible motions of the wheel axle, relative to the chassis, using methods from kinematic synthesis; and (ii) reducing overall actuation requirements by a judicious mix of structural equilibration design and spring assist. This process is examined in detail in the context of two candidate single-degree-of-freedom designs for the articulated-leg-wheel subsystems—a coupled-serial-chain configuration and a four-bar configuration. We considered the design synthesis of planar variants of the two candidate designs surmounting a representative obstacle profile while supporting a set of end-effector loads and highlight the key benefits in the presented results.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleKinetostatic Design Considerations for an Articulated Leg-Wheel Locomotion Subsystem
dc.typeJournal Paper
dc.journal.volume128
dc.journal.issue1
dc.journal.titleJournal of Dynamic Systems, Measurement, and Control
dc.identifier.doi10.1115/1.2168481
dc.journal.fristpage112
dc.journal.lastpage121
dc.identifier.eissn1528-9028
dc.keywordsDesign
dc.keywordsAccuracy
dc.keywordsWheels
dc.keywordsMechanisms
dc.keywordsSprings AND Optimization
dc.treeJournal of Dynamic Systems, Measurement, and Control:;2006:;volume( 128 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record