| dc.contributor.author | Yusuke Kawato | |
| dc.contributor.author | Won-jong Kim | |
| dc.date.accessioned | 2017-05-09T00:19:15Z | |
| dc.date.available | 2017-05-09T00:19:15Z | |
| dc.date.copyright | December, 2006 | |
| dc.date.issued | 2006 | |
| dc.identifier.issn | 0022-0434 | |
| dc.identifier.other | JDSMAA-26362#980_1.pdf | |
| dc.identifier.uri | http://yetl.yabesh.ir/yetl/handle/yetl/133357 | |
| dc.description.abstract | This paper presents a novel precision position-sensing methodology using two-axis Hall-effect sensors, where the absolute multi-degree-of-freedom (DOF) positioning of a device above any magnet matrix is possible. Magnet matrices have a periodic magnetic field about each of its orthogonal axes, which can be modeled using Fourier series. This position-sensing methodology was implemented on a Halbach-magnet-matrix-based magnetic-levitation (maglev) stage. It enables unrestricted translational and rotational ranges in planar motions with a potential 6-DOF motion-measuring capability. A Gaussian least-squares differential-correction (GLSDC) algorithm was developed and implemented to estimate the maglev stage’s position and orientation in three planar DOFs from raw Hall-effect-sensor measurements. Experimental results show its position resolution of better than 10μm in translation and 100μrad in rotation. The maximum rotational range achieved so far is 16deg, a factor of 100 improvement of a typical laser interferometers’ rotational range of a few milliradians. Classical lead-lag compensators were designed and implemented on a digital signal processor (DSP) to close the control loop at a sampling frequency of 800Hz for the three planar DOFs using the GLSDC outputs. Calibration was performed by comparing the Hall-effect sensors’ outputs against the laser-interferometer readings, which improved the positioning accuracy by correcting the GLSDC error. The experimental results exhibit better than a micrometer repeatability. This multi-DOF sensing mechanism is an excellent cost-effective solution to planar micro-positioning applications with unrestricted three-axis travel ranges. | |
| dc.publisher | The American Society of Mechanical Engineers (ASME) | |
| dc.title | Multi-Degree-of-Freedom Precision Position Sensing and Motion Control Using Two-Axis Hall-Effect Sensors | |
| dc.type | Journal Paper | |
| dc.journal.volume | 128 | |
| dc.journal.issue | 4 | |
| dc.journal.title | Journal of Dynamic Systems, Measurement, and Control | |
| dc.identifier.doi | 10.1115/1.2363201 | |
| dc.journal.fristpage | 980 | |
| dc.journal.lastpage | 988 | |
| dc.identifier.eissn | 1528-9028 | |
| dc.keywords | Hall effect | |
| dc.keywords | Sensors | |
| dc.keywords | Algorithms | |
| dc.keywords | Lasers | |
| dc.keywords | Interferometers | |
| dc.keywords | Magnets | |
| dc.keywords | Accuracy | |
| dc.keywords | Errors | |
| dc.keywords | Resolution (Optics) | |
| dc.keywords | Motion | |
| dc.keywords | Mechanisms AND Control equipment | |
| dc.tree | Journal of Dynamic Systems, Measurement, and Control:;2006:;volume( 128 ):;issue: 004 | |
| dc.contenttype | Fulltext | |