Show simple item record

dc.contributor.authorJ. Błachut
dc.date.accessioned2017-05-09T00:17:37Z
dc.date.available2017-05-09T00:17:37Z
dc.date.copyrightMay, 2005
dc.date.issued2005
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28454#151_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/132525
dc.description.abstractTests on two internally pressurized toroidal shells are described in this paper. These were laboratory scale models manufactured by welding 90°, 316L steel elbows. The outside diameter of the toroids was about 310.0 mm, radius of the tube was about 41.0 mm, and the wall thickness was about 3.0 mm. Comparison of experimental and numerical plastic loads, based on pressure versus volume change plots, is given. The magnitude of experimentally derived plastic loads was about 16.0 MPa which was close to the numerical predictions. Both shells failed by developing cracks in welds, at nozzles, at pressure of about 33.0 MPa.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titlePlastic Loads for Internally Pressurized Toroidal Shells
dc.typeJournal Paper
dc.journal.volume127
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1858925
dc.journal.fristpage151
dc.journal.lastpage156
dc.identifier.eissn1528-8978
dc.keywordsPressure
dc.keywordsStress
dc.keywordsShells AND Wall thickness
dc.treeJournal of Pressure Vessel Technology:;2005:;volume( 127 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record