Show simple item record

dc.contributor.authorJ. Bruce Nestleroth
dc.contributor.authorRichard J. Davis
dc.date.accessioned2017-05-09T00:17:35Z
dc.date.available2017-05-09T00:17:35Z
dc.date.copyrightAugust, 2005
dc.date.issued2005
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28457#274_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/132499
dc.description.abstractThis paper describes the design of a new magnetic flux leakage (MFL) inspection tool that performs an inline inspection to detect and characterize both metal loss and mechanical damage defects. An inspection tool that couples mechanical damage assessment as part of a routine corrosion inspection is expected to have considerably better prospects for application in the pipeline industry than a tool that complicates existing procedures. The design is based on study results that show it is feasible to detect and assess mechanical damage by applying a low magnetic field level in addition to the high magnetic field employed by most inspection tools. Nearly all commercially available MFL tools use high magnetic fields to detect and size metal loss such as corrosion. A lower field than is commonly applied for detecting metal loss is appropriate for detecting mechanical damage, such as the metallurgical changes caused by impacts from excavation equipment. The lower field is needed to counter the saturation effect of the high magnetic field, which masks and diminishes important components of the signal associated with mechanical damage. Finite element modeling was used in the design effort and the results have shown that a single magnetizer with three poles is the most effective design. Furthermore, it was found that for the three-pole system the high magnetization pole must be in the center, which was an unexpected result. The three-pole design has mechanical advantages, including a magnetic null in the backing bar, which enables installation of a pivot point for articulation of the tool through bends and restrictions. This design was prototyped and tested at Battelle’s Pipeline Simulation Facility (West Jefferson, OH). The signals were nearly identical to results acquired with a single magnetizer reconfigured between tests to attain the appropriate high and low field levels.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleThe Design of a Mechanical Damage Inspection Tool Using Dual Field Magnetic Flux Leakage Technology
dc.typeJournal Paper
dc.journal.volume127
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1989349
dc.journal.fristpage274
dc.journal.lastpage283
dc.identifier.eissn1528-8978
dc.keywordsMagnetic fields
dc.keywordsMagnetic flux
dc.keywordsPoles (Building)
dc.keywordsMagnetization
dc.keywordsDesign
dc.keywordsInspection
dc.keywordsPipelines
dc.keywordsPipes
dc.keywordsLeakage
dc.keywordsEquipment and tools
dc.keywordsMagnets
dc.keywordsModeling AND Signals
dc.treeJournal of Pressure Vessel Technology:;2005:;volume( 127 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record