Show simple item record

dc.contributor.authorHenrique Reis
dc.contributor.authorDaniel A. Kuchma
dc.contributor.authorJennifer T. Bernhard
dc.contributor.authorBenjamin L. Ervin
dc.date.accessioned2017-05-09T00:17:35Z
dc.date.available2017-05-09T00:17:35Z
dc.date.copyrightAugust, 2005
dc.date.issued2005
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28457#255_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/132496
dc.description.abstractCorrosion of reinforced concrete is a chronic infrastructure problem, particularly in areas with deicing salt and marine exposure. To maintain structural integrity, a testing method is needed to identify areas of corroding reinforcement. For purposes of rehabilitation, the method must also be able to evaluate the degree, rate, and location of damage. Toward the development of a wireless embedded sensor system to monitor and assess corrosion damage in reinforced concrete, reinforced mortar specimens were manufactured with seeded defects to simulate corrosion damage. Taking advantage of waveguide effects of the reinforcing bars, these specimens were then tested using an ultrasonic approach. Using the same ultrasonic approach, specimens without seeded defects were also monitored during accelerated corrosion tests. Both the ultrasonic sending and the receiving transducers were mounted on the steel rebar. Advantage was taken of the lower frequency (<250kHz) fundamental flexural propagation mode because of its relatively large displacements at the interface between the reinforcing steel and the surrounding mortar. Waveform energy (indicative of attenuation) is presented and discussed in terms of corrosion damage. Current results indicate that the loss of bond strength between the reinforcing steel and the surrounding concrete can be detected and evaluated.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleEstimation of Corrosion Damage in Steel Reinforced Mortar Using Guided Waves
dc.typeJournal Paper
dc.journal.volume127
dc.journal.issue3
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1989352
dc.journal.fristpage255
dc.journal.lastpage261
dc.identifier.eissn1528-8978
dc.keywordsMortar
dc.keywordsWaves
dc.keywordsCorrosion
dc.keywordsSteel
dc.keywordsConcretes
dc.keywordsTesting
dc.keywordsTransducers AND Signals
dc.treeJournal of Pressure Vessel Technology:;2005:;volume( 127 ):;issue: 003
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record