Show simple item record

dc.contributor.authorFadi K. Abu-Farha
dc.contributor.authorMarwan K. Khraisheh
dc.date.accessioned2017-05-09T00:16:19Z
dc.date.available2017-05-09T00:16:19Z
dc.date.copyrightJanuary, 2005
dc.date.issued2005
dc.identifier.issn0094-4289
dc.identifier.otherJEMTA8-27065#159_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/131902
dc.description.abstractCurrently available models describing superplastic deformation are mostly based on uniaxial tensile test data and assume isotropic behavior, thus leading to limited predictive capabilities of material deformation and failure. In this work we present a multi-axial microstructure-based constitutive model that describes the anisotropic superplastic deformation within the continuum theory of viscoplasticity with internal variables. The model accounts for microstructural evolution and employs a generalized anisotropic dynamic yield function. The anisotropic yield function can describe the evolution of the initial state of anisotropy through the evolution of unit vectors defining the direction of anisotropy during deformation. The generalized model is then reduced to the plane stress condition to simulate sheet metal stretching in superplastic blow forming using pressurized gas. Different ratios of biaxial stretching were investigated, including the case simulating the uniaxial loading condition, where the model successfully captured the uniaxial experimental data. The model is also used to develop a new forming pressure profile that accounts for anisotropy and microstructural evolution.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleModeling of Anisotropic Deformation in Superplastic Sheet Metal Stretching
dc.typeJournal Paper
dc.journal.volume127
dc.journal.issue1
dc.journal.titleJournal of Engineering Materials and Technology
dc.identifier.doi10.1115/1.1839216
dc.journal.fristpage159
dc.journal.lastpage164
dc.identifier.eissn1528-8889
dc.keywordsPressure
dc.keywordsDeformation
dc.keywordsSheet metal
dc.keywordsSuperplasticity
dc.keywordsStress
dc.keywordsAnisotropy
dc.keywordsConstitutive equations AND Modeling
dc.treeJournal of Engineering Materials and Technology:;2005:;volume( 127 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record