Show simple item record

dc.contributor.authorNobuo Masaki
dc.contributor.authorShigenobu Suzuki
dc.date.accessioned2017-05-09T00:14:15Z
dc.date.available2017-05-09T00:14:15Z
dc.date.copyrightFebruary, 2004
dc.date.issued2004
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28433#141_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130733
dc.description.abstractWe conducted the measurement of restoring force characteristics of laminated rubber bearings under various restraining conditions. In the experiment, we provided three laminated rubber bearings with various second shape factors (S2=3,4,4.94). The restoring force is obtained by using a newly designed combined loading test apparatus. By using this apparatus, the laminated rubber bearing could be subjected to shear, compressive and rotational deformations independently. In this experiment, we defined the degree of restraint as the ratio of the bending moment to the restricting bending moment which was measured when the rotation angle of the laminated rubber bearing was zero radian. This means that the flanges on both sides of the laminated rubber bearings were kept parallel during horizontal deformations. From the experiment, it was confirmed that restoring force characteristics were affected by the degree of restraint. Some reduction in restoring forces was observed when the degree of restraint was small. In particular the laminated rubber bearing with a small second shape factor, namely the rubber bearing, had a slender shape, easily buckling under small horizontal displacement. It was also confirmed that bending stiffness of the laminated rubber bearing had shear strain dependency and vertical load i.e., surface pressure dependency. The results of this experiment reveal that we should consider the reduction of the restoring force if the upper or lower structure of the laminated rubber bearing is not sufficiently rigid.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleRestoring Force Characteristics of Laminated Rubber Bearings Under Various Restraining Conditions
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue1
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1637643
dc.journal.fristpage141
dc.journal.lastpage147
dc.identifier.eissn1528-8978
dc.keywordsForce
dc.keywordsRubber
dc.keywordsBearings
dc.keywordsDisplacement
dc.keywordsShapes
dc.keywordsRotation
dc.keywordsStress
dc.keywordsStiffness AND Flanges
dc.treeJournal of Pressure Vessel Technology:;2004:;volume( 126 ):;issue: 001
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record