Show simple item record

dc.contributor.authorPaul Feenstra
dc.contributor.authorDavid S. Weaver
dc.contributor.authorZia Abdullah
dc.date.accessioned2017-05-09T00:14:12Z
dc.date.available2017-05-09T00:14:12Z
dc.date.copyrightMay, 2004
dc.date.issued2004
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28438#269_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130710
dc.description.abstractA wind tunnel study was carried out to investigate the fluidelastic stability of a model heat exchanger tube array subjected to a uniform cross-flow of air and a concentrated jet flow of air directed down a tube lane. The latter experiments were intended to simulate the effects of a soot blower on the dynamic response of tubes which had apparently been the cause of catastrophic tube failure in a heat exchanger. The experimental results showed that the model tube array experienced fluidelastic instability when subjected to a uniform cross-flow beyond a dimensionless pitch flow velocity which was substantially above the maximum design flow velocity of the heat exchanger. These experiments established that normal operating conditions could not have been responsible for the tube failures. Additional experiments showed that a continuously translating nozzle dispensing a jet of air at the tubes caused some static deflection of the tubes but no serious vibrations were observed. However, when the nozzle was fixed at one location, whereby the jet of air issued directly down a tube lane, fluidelastic instability occurred in the first few tube rows. A simplified analysis showed that the jet could cause fluidelastic instability. It can be inferred that, for heat exchangers equipped with steam soot blowers, normal soot blower operation should not cause fluidelastic instability but that a parked soot blower can cause fatigue failure of the tubes adjacent to the impinging jet in a relatively short period of time.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleFluid-Elastic Instability in a Tube Array Subjected to Uniform and Jet Flow
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1689356
dc.journal.fristpage269
dc.journal.lastpage274
dc.identifier.eissn1528-8978
dc.keywordsFlow (Dynamics)
dc.keywordsFluids
dc.keywordsJets
dc.keywordsHeat exchangers
dc.keywordsVibration
dc.keywordsFailure
dc.keywordsSoot
dc.keywordsWind tunnels
dc.keywordsNozzles
dc.keywordsSteam
dc.keywordsStability
dc.keywordsCross-flow AND Fatigue failure
dc.treeJournal of Pressure Vessel Technology:;2004:;volume( 126 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record