Show simple item record

dc.contributor.authorR. Seshadri
dc.contributor.authorH. Indermohan
dc.date.accessioned2017-05-09T00:14:12Z
dc.date.available2017-05-09T00:14:12Z
dc.date.copyrightMay, 2004
dc.date.issued2004
dc.identifier.issn0094-9930
dc.identifier.otherJPVTAS-28438#237_1.pdf
dc.identifier.urihttp://yetl.yabesh.ir/yetl/handle/yetl/130705
dc.description.abstractThe existing lower bound limit load determination methods, that are based on linear elastic analysis such as the classical and mα-multiplier methods, have a dependence on the maximum equivalent stress. These methods are therefore sensitive to localized plastic action, which occurs in components with thin or slender construction, or those containing notches and cracks. Sensitivity manifests itself as relatively poor lower bounds during the initial elastic iterations of the elastic modulus adjustment procedures, or oscillatory behavior of the multiplier during successive elastic iterations leading to limited accuracy. The mβ-multiplier method proposed in this paper starts out with Mura’s inequality that relates the upper bound to the exact multiplier by making use of the “integral mean of yield.” The formulation relies on a “reference parameter” that is obtained from considering a distribution of stress rather than a single maximum equivalent stress. As a result, good limit load estimates have been obtained for several pressure component configurations.
dc.publisherThe American Society of Mechanical Engineers (ASME)
dc.titleLower Bound Limit Load Determination: The mβ-Multiplier Method
dc.typeJournal Paper
dc.journal.volume126
dc.journal.issue2
dc.journal.titleJournal of Pressure Vessel Technology
dc.identifier.doi10.1115/1.1688780
dc.journal.fristpage237
dc.journal.lastpage240
dc.identifier.eissn1528-8978
dc.keywordsStress AND Pressure
dc.treeJournal of Pressure Vessel Technology:;2004:;volume( 126 ):;issue: 002
dc.contenttypeFulltext


Files in this item

Thumbnail

This item appears in the following Collection(s)

Show simple item record